|
樓主 |
發表於 2010/1/28 21:40:24
|
顯示全部樓層
第二題
修改先前所畫的模型並進行以下的設變
(特別注意是修改 不是重建 在同一個模型上進行增加模型特徵 不是另存新檔成另一個零件再畫)
Modify the part using the following dimensions
(These images are to be used to
answer Questions #4 and 5)
Note: The changes from the initial part are concentrated in areas AA, BB and CC shown in
the first two images.
Unit system: MMGS (millimeter, gram, second)
Decimal places: 2
Part origin: Arbitrary
Material: Alloy Steel
Density = 0.0077 g/mm^3
All holes through all unless shown otherwise
-Use the following parameters and equations which correspond to the dimensions labeled in the
images:
A = 221 mm
B = 211 mm
C = 165 mm
D = 121 mm
E = 37 mm
X = A/3
Y = B/3 + 15mm
Note: The equation for Y has changed from the initial part.
Hint #1: The dimensions that are to be linked or updated and are variable will be labeled with
letters. Any dimensions that are simple value changes from one stage to another will be circled in
the images.
Hint #2: To save the most time, make use of linked dimensional values and equations.
-Measure the mass of the part.
What is the mass of the part (grams)?
a) 13095.40
b) 13206.40
c) 13313.35
d) 13395.79 |
|